• hand-wash only: warm water, mild dish soap & a soft brush.
• not dishwasher-safe — high heat may warp PLA & PETG prints.
• dry immediately & store flat to keep edges crisp.
• food-safe at up to 50 °C / 122 °F contact temperature.

wipe the board and tiles with a damp cloth; avoid soaking.
stubborn icing or chalk? use a soft toothbrush + warm soapy water, rinse & pat dry.
store tiles in the cotton pouch provided to prevent loss.

treat like electronics: avoid bending the tag’s antenna.
clean with microfiber + isopropyl wipe.
do not microwave or expose to >60 °C — chip failure risk.

dust with cornflour between presses for clean release.
rinse gently; avoid metal scrubbers that may scratch detail.

• keep prints away from direct sunlight to reduce colour fade.
• ideal storage temp: 10–30 °C / 50–86 °F, low humidity.
• small scratches? buff lightly with 600-800 grit sandpaper.
• normal lifespan: 3–5 years of weekly use; recycle in #7 plastics at end of life.

care qs? email hello@pix3l.com.au or dm @pix3lprints (mon-fri, 9 am–4 pm aest).

email us.